No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the RPF Route Configuration

Verifying the RPF Route Configuration

After configuring Reverse Path Forwarding (RPF) routes, verify configuration of the RPF routes.


RPF routes have been configured.


  1. Run the display multicast [ vpn-instance vpn-instance-name | all-instance ] rpf-info source-address [ group-address ] [ rpt | spt ] command to check information about the source-specific RPF route.


Run the display multicast rpf-info source-address command. The command output shows RPF routing information about a specified multicast source, including the RPF interface, RPF neighbor, optimal route and type of the route, and configured multicast load splitting policy.

<HUAWEI> display multicast rpf-info
VPN-Instance: public net
 RPF information about source:
     RPF interface: GigabitEthernet6/0/0, RPF neighbor:
     Referenced route/mask:
     Referenced route type: unicast
     Route selection rule: preference-preferred
     Load splitting rule: stable-preferred
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 40755

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next