No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summarizing Local MBGP Routes

Summarizing Local MBGP Routes

Configuring route summarization can reduce the size of a routing table on a peer.

Context

On a large-scale MBGP network, configuring route summarization can reduce the number of advertised route prefixes and improve MBGP stability.

MBGP supports automatic and manual route summarization.

Procedure

  • Configure automatic route summarization.
    1. Run system-view

      The system view is displayed.

    2. Run bgp as-number

      The BGP view is displayed.

    3. Run ipv4-family multicast

      The BGP-IPv4 multicast address family view is displayed.

    4. Run summary automatic

      Subnet routes are summarized based on natural network segment masks.

      This command summarizes the routes imported into the MBGP routing table. The routes may be direct routes, static routes, RIP routes, OSPF routes, or IS-IS routes. Note that this command is invalid for the routes imported by using the network command.

    5. Run commit

      The configuration is committed.

  • Configure manual route summarization.
    1. Run system-view

      The system view is displayed.

    2. Run bgp as-number

      The BGP view is displayed.

    3. Run ipv4-family multicast

      The BGP-IPv4 multicast address family view is displayed.

    4. Run one of the following commands to configure route summarization as needed.

      • To advertise all summarized routes and specific routes, run:

        aggregate ipv4-address { mask | mask-length }
      • To advertise only summarized routes, run:

        aggregate ipv4-address { mask | mask-length } detail-suppressed
      • To advertise specific routes, run:

        aggregate ipv4-address { mask | mask-length } suppress-policy route-policy-name3

        Using the peer route-policy command can also advertise specific routes.

      • To generate the summarized route used for loop detection, run:

        aggregate ipv4-address { mask | mask-length } as-set
      • To configure the attributes of summarized routes, run:

        aggregate ipv4-address { mask | mask-length } attribute-policy route-policy-name1

        The peer route-policy command can also configure the attributes of summarized routes.

        If as-set is configured in the aggregate command, the AS_Path attribute configured in the apply as-path command does not take effect.

      • To generate summarized routes based on some of the specific routes, run:

        aggregate ipv4-address { mask | mask-length } origin-policy route-policy-name2

      Only the routes that exist in the local MBGP routing table can be manually summarized. For example, if the route 10.1.1.1/24 is not in the MBGP routing table, MBGP will not advertise the route summarized by using the aggregate 10.1.1.1 16 command.

    5. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 42734

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next