No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling a QinQ/Dot1q VLAN Tag Termination Sub-interface to Forward Single-Tagged IPv6 PIM Messages

Enabling a QinQ/Dot1q VLAN Tag Termination Sub-interface to Forward Single-Tagged IPv6 PIM Messages

If a QinQ/dot1q VLAN tag termination sub-interface of a local device is connected to a device that sends single-tagged IPv6 PIM messages, enable the sub-interface to forward single-tagged IPv6 PIM messages. Otherwise, the communication failures.

Context

If a QinQ/dot1q VLAN tag termination sub-interface on the router is connected to a downstream router that sends single-tagged IPv6 PIM messages, the sub-interface discards the IPv6 PIM messages by default.

To resolve this issue, enable the QinQ/dot1q VLAN tag termination sub-interface to forward single-tagged IPv6 PIM messages.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run multicast ipv6 routing-enable

    IPv6 Multicast routing is enabled.

    Running the undo multicast ipv6 routing-enable command deletes all IPv6 multicast configurations and interrupts IPv6 multicast services. To restore the IPv6 multicast services, you must revert the deleted IPv6 multicast configurations.

  3. Run interface interface-type interface-number .subinterface-number

    The sub-interface view is displayed.

  4. Run pim ipv6 single-tag forward enable

    The QinQ/dot1q VLAN tag termination sub-interface is enabled to forward single-tagged IPv6 PIM messages.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 39675

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next