No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adjusting BSR RP Parameters (IPv6)

Adjusting BSR RP Parameters (IPv6)

If a BootStrap router (BSR) Rendezvous Point (RP) is used, you can adjust parameters about Candidate-Rendezvous Points (C-RPs) and Candidate-BootStrap Routers (C-BSRs)

Usage Scenario

Initially, each C-BSR considers itself as a BSR and sends a Bootstrap message to the entire network. Each router receives the Bootstrap messages sent by all C-BSRs. By comparing the information carried by the Bootstrap messages, the routers elect a BSR.

All routers know the BSR address. The C-RPs send Advertisement messages to the BSR. An Advertisement message sent by a C-RP carries the address of the C-RP, the range of multicast groups that the C-RP serves, and the priority of the C-RP. The BSR collects C-RP information and summarizes information into an RP-Set, encapsulates the RP-Set in a Bootstrap message, and advertises the Bootstrap message to each router. Based on the RP-Set, each router performs the RP calculation by using the same rule and elects the RP for a specific group from multiple C-RPs to which this group corresponds.

The router can work normally by using default parameter values. The NE40E allows you to adjust BSR RP parameters as needed.

NOTE:

If there is no special requirement, default parameter values are recommended.

Pre-configuration Tasks

Before adjusting dynamic RP parameters, complete the following tasks:

  • Configure an IPv6 unicast routing protocol to ensure that IPv6 unicast routes are reachable.

  • Configure IPv6 PIM-SM and configure the system to use a BSR RP.

Configuration Procedures

Perform one or more of the following configurations as required.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 44278

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next