No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of the Policy for Processing MLD Packets

Verifying the Configuration of the Policy for Processing MLD Packets

After configuring the Policy for Processing MLD Packets, verify MLD configurations and running information on the interface to ensure normal running of MLD.

Prerequisites

The Policy for Processing MLD Packets has been configured.

Procedure

  • Run the display mld interface [ interface-type interface-number | up | down ] [ verbose ] command to check configurations and running information about MLD on a specified interface.

Example

Run the display mld interface verbose command to view detailed information about an MLD interface. The command output shows that GE 1/0/0 is configured to deny MLD messages that do not contain the Router-Alert option and is enabled to filter MLD Report, Done, and MLD Query messages based on source addresses. For example:

<HUAWEI> display mld interface verbose
Interface information
 GigabitEthernet1/0/0(FE80::2E0:B4FF:FE35:FF01):
   MLD is enabled
   Current MLD version is 2
   MLD state: up
   MLD group policy: none
   Value of query interval for MLD (negotiated): 125 s
   Value of query interval for MLD (configured): 125 s
   Value of other querier timeout for MLD: 0 s
   Value of maximum query response time for MLD: 10 s
   Value of last listener query time: 2 s
   Value of last listener query interval: 1 s
   Value of startup query interval: 31 s
   Value of startup query count: 2
   General query timer expiry (hours:minutes:seconds): 00:00:28
   Querier for MLD: FE80::2E0:B4FF:FE35:FF01 (this router)
   MLD activity: 0 joins, 0 dones
   Robustness (negotiated): 2
   Robustness (configured): 2
   Require-router-alert: enabled
   Send-router-alert: enabled
   Ip-source-policy: ab
   Query ip-source-policy: 2000
   Prompt-leave: disabled
   SSM-Mapping: disabled
   Startup-query-timer-expiry: on
   Other-querier-present-timer-expiry: off
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 40665

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next