No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling IPv6 Multicast Services to Run in a Unicast Topology Instance

Enabling IPv6 Multicast Services to Run in a Unicast Topology Instance

Using a unicast topology or the base topology instance for IPv6 multicast services is applicable only to the PIM-SM intra-domain scenario.



Before enabling multicast services to run in a specified unicast topology instance, you must configure a multicast topology instance and a unicast topology instance in the system view.

For configuration details, see Configuring IPv6 Multi-Topologies. Make sure that topology-name is multicast.


  1. Run system-view

    The system view is displayed.

  2. Run multicast ipv6 rpf multi-topology

    The IPv6 multicast multi-topology view is displayed.

  3. Run apply topology topology-name

    IPv6 multicast services are enabled to run in a unicast topology instance or the base topology instance.

  4. Run commit

    The configuration is committed.

Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 44214

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next