No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Multicast Forwarding Boundary

Configuring the Multicast Forwarding Boundary

When an interface of a multicast device is configured with a forwarding boundary for a specified group, the forwarding scope of multicast packets is restricted.

Context

By default, no multicast forwarding boundary is configured on an interface.

Perform the following steps on the multicast router:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run multicast boundary group-address { mask | mask-length }

    The multicast forwarding boundary is configured.

Checking the Configurations

Run the display multicast [ vpn-instance vpn-instance-name | all-instance ] boundary [ group-address [ mask | mask-length ] ] [ interface interface-type interface-number ] command to check information about the multicast boundary configured on an interface.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 40473

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next