No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Multicast 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Deleting MLD Group Information

Deleting MLD Group Information

If MLD group information is unnecessary, delete it in the user view.

Context

The reset mld group or reset mld group ssm-mapping command deletes information about the MLD groups that an interface dynamically joins, which may cause receivers to fail to receive multicast data . Exercise caution when running this command.

Procedure

  • To delete information about the MLD groups (excluding the MLDv1 groups in the SSM group address range) that an interface dynamically joins, run the following commands in the user view:

    • reset mld group all

    • reset mld group interface interface-type interface-number { all | ipv6-group-address [ ipv6-group-mask-length ] [ ipv6-source-address [ ipv6-source-mask-length ] ] }

  • To delete information about the MLDv1 groups in the SSM group address range, run the following commands in the user view:

    • reset mld group ssm-mapping all
    • reset mld group ssm-mapping interface interface-type interface-number { all | ipv6-group-address [ ipv6-group-mask-length ] }

  • To delete information about the MLD groups that an interface statically joins, run the undo mld static-group { all | ipv6-group-address [ source ipv6-source-address ] } command in the user view.
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055017

Views: 43361

Downloads: 97

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next