No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - IP Routing 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Routing
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RIP Network Management

Configuring RIP Network Management

By binding RIP and MIBs, you can view and configure RIP through the NMS.

Usage Scenario

Through Simple Network Management Protocol (SNMP), the RIP Management Information Base (MIB) manages multicast information exchanged between the NMS and agents.

Pre-configuration Tasks

Before controlling RIP configuration through an SNMP agent, complete the following tasks:


  1. Run system-view

    The system view is displayed.

  2. Run rip mib-binding process-id

    The MIB is bound to the RIP process ID, and the ID of the RIP process that accepts SNMP requests is specified.

  3. Run commit

    The configuration is committed.

Checking the Configurations

Run the following commands to check the previous configuration.

  • Run the display current-configuration command to check the valid parameters on the device.

<HUAWEI> display current-configuration
 rip mib-binding 1
 interface GigabitEthernet3/0/0
 undo shutdown
 ip address
 undo rip input
rip 1
 description RIP_Network1
 import-route static cost 0
Updated: 2019-01-03

Document ID: EDOC1100055018

Views: 48247

Downloads: 201

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next