No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - IP Routing 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Routing
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IPv6 Multi-Topology

Configuring IPv6 Multi-Topology

Multi-topology on an IPv6 network enables devices to allocate network resources more effectively.

Usage Scenario

On traditional IPv6 networks, only one unicast forwarding table is available on the forwarding plane because only one unicast topology exists, which forces services transmitted from one router to the same destination address to share the same next hop, and various end-to-end services, such as voice and data services, to share the same physical links. As a result, some links may be heavily congested while others remain relatively idle. Deploying MT (different logical topologies) for different services on a physical network can solve the problem.

Pre-configuration Tasks

Before configuring IPv6 Multi-Topology, complete the following tasks:

  • Configure parameters of the link layer protocol and IPv6 addresses for interfaces and ensure that the link layer protocol on the interfaces is Up.


  1. Run system-view

    The system view is displayed.

  2. Run ipv6 topology topology-name

    An IPv6 topology is created.

  3. Run interface interface-type interface-name

    The view of the specified interface is displayed.

  4. Run ipv6 topology topology-name enable

    The topology is bound to the interface.

  5. Run commit

    The configuration is committed.

Checking the Configurations

Run the display ipv6 topology command to check the previous configuration.

# Run the display ipv6 topology [ topology-name [ verbose ] ] command to view information about topologies.

<HUAWEI> display ipv6 topology tp1 verbose
 Topology Name          : tp1
 Topology ID            : 0x0500
Updated: 2019-01-03

Document ID: EDOC1100055018

Views: 55122

Downloads: 211

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next