No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Routing 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Routing
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Route Iteration to the Default Route

Configuring Route Iteration to the Default Route

Route iteration to the default route allows the unicast static routes, BGP routes, or multicast static routes whose next hops are not directly reachable to be iterated to the default route.

Usage Scenario

The next hops of unicast static routes, BGP routes, or multicast static routes may not be directly reachable. In this case, iteration is required so that such routes can be used for traffic forwarding. To allow the unicast static routes, BGP routes, or multicast static routes whose next hops are not directly reachable to be iterated to the default route, run the { ip | ipv6 } route recursive-lookup default-route command.

Pre-configuration Tasks

None

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ip route recursive-lookup default-route protocol { static | bgp | msr } or ipv6 route recursive-lookup default-route protocol { static | bgp }

    Route iteration to the default route is enabled.

  3. Run commit

    The configuration is committed.

Checking the Configurations

After configuring route iteration to the default route, run the display current-configuration command in the system view to check configurations. The command output shows that route iteration to the default route is configured.

<HUAWEI> display current-configuration
#
ip route recursive-lookup default-route protocol static
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055018

Views: 53988

Downloads: 209

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next