No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - IP Routing 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Routing
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Prefix-based BGP ORF

Configuring Prefix-based BGP ORF

Prefix-based BGP ORF enables a device to send its peer the local prefix-based import policy so that the peer can use the policy to filter routes before sending them to the local device.

Usage Scenario

When a device expects to receive only required routes from the remote device and the remote end does not want to maintain a separate export policy for each connected peer, you can configure prefix-based ORF which supports on-demand route advertisement.

Pre-configuration Tasks

Before configuring prefix-based BGP ORF, complete the following tasks:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bgp as-number

    The BGP view is displayed.

  3. Run ipv4-family unicast

    The IPv4 unicast address family view is displayed.

  4. Run peer { group-name | ipv4-address } ip-prefix ip-prefix-name import

    A prefix-based import policy is configured to filer routes advertised by the specified peer or peer group.

  5. Run peer { group-name | ipv4-address } capability-advertise orf [ non-standard-compatible ] ip-prefix { both | receive | send }

    The prefix-based ORF is configured for the specified peer or peer group.

  6. Run commit

    The configuration is committed.

Checking the Configurations

Run the following command to check the previous configuration.
  • Run the display bgp peer [ ipv4-address ] verbose command to check detailed information about BGP peers.

  • Run the display bgp peer ipv4-address orf ip-prefix command to check routes received from a specified peer after the prefix-based ORF is configured.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055018

Views: 48505

Downloads: 201

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next