No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - IP Routing 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Routing
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Maintaining RIP

Maintaining RIP

RIP maintenance is implemented through debugging which affects system performance.

Clearing RIP

If you want to clear information about RIP, run the reset commands in the user view.


RIP information cannot be restored after you clear it. Therefore, exercise caution when running the following commands.


  • Run the reset rip { process-id | all } configuration command to reset the configuration parameters of the specific RIP process. When the RIP process is initiated, the default configuration parameters are restored to the default values.
  • Run the reset rip { process-id | all } imported-routes command to clear the routes imported from other routing protocols and then import these routes into RIP again.
  • Run the reset rip { process-id | all } statistics [ interface interface-type interface-number ] command to clear the statistics of the counter that is maintained by a particular RIP process. This command helps to re-collect statistics during debugging.

Debugging RIP

Routers can generate associated debugging information after you enable the debugging of modules in the user view. Debugging information displays the contents of the packets sent or received by the debugged modules.


Debugging affects system performance. Therefore, after debugging, run the undo debugging all command to disable it immediately.

When a RIP fault occurs, run any of the following debugging commands in the user view to debug RIP and locate the fault.

For detailed procedure of displaying the debugging information, see "Information Center Configuration" in the HUAWEI NetEngine40E Universal Service Router Configuration Guide - System Management.


  1. Run the debugging rip process-id packet [ send | receive ] [ error ] [ verbose] [ interface interface-type interface-number [ peer peer-address ] ] command to debug the RIP packets sent or received on the network.
  2. Run the debugging rip process-id route [ error | backup ] [ imported | { interface interface-type interface-number [ peer peer-address ] } ] command to debug RIP routes.
  3. Run the debugging rip miscellaneous command to debug RIP packets globally.
Updated: 2019-01-03

Document ID: EDOC1100055018

Views: 54501

Downloads: 209

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next