No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - IP Routing 01

This is NE40E V800R010C10SPC500 Configuration Guide - IP Routing

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Maintaining IS-IS

Maintaining IS-IS

Maintaining IS-IS involves resetting IS-IS, clearing IS-IS statistics, and debugging IS-IS.

Resetting IS-IS

Resetting an IS-IS process clears all the data of the IS-IS process and re-establishes the adjacency.


Resetting an IS-IS process may cause a service interruption. Therefore, exercise caution when running this command.


  • Run the reset isis all [ process-id | vpn-instance vpn-instance-name ] or reset isis process-id all command to restart the IS-IS process.
  • Run the reset isis peer system-id [ process-id | vpn-instance vpn-instance-name ] or reset isis process-id peer system-id command to reset the IS-IS neighbor relationship.

Suppressing IS-IS

You can disable an IS-IS process temporarily by suppressing IS-IS without affecting IS-IS configurations.


  1. Run system-view

    The system view is displayed.

  2. Run isis [ process-id ]

    An IS-IS process is started, and the IS-IS view displayed.

  3. Run shutdown

    The IS-IS process is disabled temporarily.

    After the IS-IS process is disabled temporarily, you can still perform IS-IS configurations but the configurations do not take effect. You can run the undo shutdown command to cancel the suppression.

  4. Run commit

    The configuration is committed.

Updated: 2019-01-03

Document ID: EDOC1100055018

Views: 66350

Downloads: 240

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next