No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - QoS 01

This is NE40E V800R010C10SPC500 Configuration Guide - QoS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Uniform/Pipe Mode for MPLS TE

Configuring the Uniform/Pipe Mode for MPLS TE

This section describes the process of configuring the Uniform/Pipe mode for MPLS TE.

Usage Scenario

To ensure the scheduling priorities of different MPLS TE services on the MPLS public network, you need to configure the Uniform/Pipe mode.

Pre-configuration Tasks

Before configuring the MPLS TE Uniform/Pipe mode, complete the following tasks:

  • Configuring physical parameters and link attributes for related interfaces to ensure normal operation of the interfaces

  • Configuring an MPLS TE tunnel between two PEs (For details, see "MPLS TE Configuration" in the HUAWEI NetEngine40E Configuration Guide - MPLS.)

NOTE:

Before configuring the Uniform/Pipe mode for MPLS TE, check that the MPLS TE is Up.

After the following operations are performed on the user-side tunnel interface on the ingress PE, the configured mode takes effect only on the ingress PE. The penultimate node uses the Uniform mode by default.

To change the Diff-Serv mode for the penultimate node, see the section "Configuring the Uniform/Pipe mode for the MPLS penultimate node".

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel interface-number

    The view of the user-side tunnel interface is displayed.

  3. Run diffserv-mode { pipe service-class color | uniform }

    A Diff-Serv mode is set for the MPLS.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055024

Views: 25349

Downloads: 117

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next