No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - QoS 01

This is NE40E V800R010C10SPC500 Configuration Guide - QoS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Specifying a Resource Pool of Queues for an Interface

(Optional) Specifying a Resource Pool of Queues for an Interface

This section describes how to specify a resource pool of queues for an interface.

Context

Perform the following steps on the router:

The SQs that are available for incoming or outgoing traffic on an interface are limited. To resolve the problem that the available SQs are insufficient for an interface, you can specify a resource pool of queues for an interface.

Procedure

  • Specifying a resource pool of queues in mode2.
    1. Run system-view

      The system view is displayed.

    2. Run qos scheduling-mode mode2 slot slot-id

      The scheduling mode is set to mode2 on a board.

      NOTE:

      The queue resource pool configuration takes effect only when the scheduling mode is set to mode2.

    3. Run interface interface-type interface-number

      The interface view is displayed.

    4. Run qos queue-resource pool id { inbound | outbound }

      A resource pool of queues is specified on the interface.

    5. Run commit

      The configuration is committed.

  • Specifying a resource pool of queues in mode3.
    1. Run system-view

      The system view is displayed.

    2. Run qos scheduling-mode mode3 slot slot-id

      The scheduling mode is set to mode3 on a board.

    3. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055024

Views: 23097

Downloads: 115

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next