No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - QoS 01

This is NE40E V800R010C10SPC500 Configuration Guide - QoS

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Rate Limit Mode for Common Users

Configuring the Rate Limit Mode for Common Users

The system schedules traffic from common users by obtaining CAR and SQ parameters defined in the QoS profile based on the rate limit mode configured for the common users.

Context

Perform the following steps on the router:

This configuration is supported only on the Admin VS.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run aaa

    The AAA view is displayed.

  3. Run domain domain-name

    A domain is created and the AAA domain view is displayed.

    Here, domain-name specifies the domain to which the service is mapped.

  4. Run qos rate-limit-mode { car | user-queue } { inbound | outbound }

    The rate limit mode for common users is configured.

    When a QoS profile is applied in an AAA domain, if the QoS profile contains both the car and user-queue parameters, the system determines whether the qos rate-limit-mode command is configured in the domain. If the qos rate-limit-mode command is configured in the domain, the system performs traffic scheduling according to the CAR parameter in the QoS profile. If the qos rate-limit-mode user-queue command is configured in the domain, the system performs traffic scheduling according to the SQ parameter in the QoS profile.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055024

Views: 30239

Downloads: 141

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next