No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - QoS 01

This is NE40E V800R010C10SPC500 Configuration Guide - QoS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview of QPPB

Overview of QPPB

QPPB enables a BGP route sender to classify routes by setting BGP attributes.

On a large and complex network, a large number of MF classification operations are required, and routes cannot be classified based on the community attribute, ACL, IP prefix, or AS_Path. When a network topology keeps changing, configuring or changing routing policies is difficult or even impossible to implement. Therefore, the QoS Policy Propagation Through the Border Gateway Protocol (QPPB) is introduced to reduce configuration workload by configuring or changing routing policies only on a BGP route sender.

After QPPB is deployed, a BGP route sender can classify routes and set attributes for BGP routes; a BGP route receiver accordingly applies different QoS policies to different types of BGP routes based on the set attributes.

QPPB is implemented as follows:

  • Before sending BGP routes, a route sender sets a specific attribute, such as the AS_Path, community attribute, or extended community attribute, for BGP routes. These attributes are used to identify BGP routes.

  • After receiving the BGP routes, a route receiver performs the following operations:

    1. Maps each received BGP route to a QoS local ID or an IP preference based on the AS_Path, community attribute, or extended community attribute.

    2. Performs different traffic behaviors for packets transmitted along the routes according to their mapped QoS local IDs.

    3. Creates a QPPB local policy and define the mappings between BGP routes and QoS policies in it.
    4. Applies the QPPB local policy to an interface.
NOTE:

QPPB enables a BGP or IS-IS route sender to classify routes by setting route attributes. This chapter introduces the QPPB application in routes in the example of BGP routes.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055024

Views: 21942

Downloads: 112

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next