No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - QoS 01

This is NE40E V800R010C10SPC500 Configuration Guide - QoS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Share-Shaping for Port Queues

(Optional) Configuring Share-Shaping for Port Queues

When the outbound interfaces of port queues with different priorities are the same main interface, you can perform share-shaping for the port queues using the same scheduling mode.


Perform the following steps on a main interface:


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run port share-shaping { af1 | af2 | af3 | af4 | be | cs6 | cs7 | ef } * [ pq | wfq weight weight-value | lpq ] { shaping-value | shaping-percentage shaping-percentage } [ pbs pbs-value ]

    Share-shaping is configured for port queues.

    If this command is configured for multiple times on an interface, the latest configuration overrides the previous configurations.

    This command cannot be configured on a trunk member interface, and the interface on which this command is configured cannot be added to a trunk interface.

    This command is supported only on an LPUI-52-E/LPUI-120-E/LPUF-480-E/LPUF-480/LPUF-480-B/LPUI-480/LPUI-480-B/LPUI-480-L/LPUI-1T/LPUI-1T-B/LPUI-1T-L/LPUI-2T/LPUI-2T-B or on an LPUF-120/LPUF-240 that is equipped with a P52-E/P120-E/P120-H/P240-E/P240-H.

  4. Run commit

    The configuration is committed.

Updated: 2019-01-03

Document ID: EDOC1100055024

Views: 22002

Downloads: 112

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next