No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

NE40E V800R010C10SPC500 Configuration Guide - QoS 01

This is NE40E V800R010C10SPC500 Configuration Guide - QoS

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MF Classification for VXLAN Packets

Configuring MF Classification for VXLAN Packets

This section describes how to configure MF classification for VXLAN packets.

Usage Scenario

MF classification can be configured to provide differentiated services for VXLAN packets based on parameters of the packets, such as the DSCP value, protocol type, IP address, or port number, to meet services' requirements on bandwidth and delay.

MF classification is usually configured on the router located at the edge of the network, whereas BA classification is configured on the router located at the core of a network.

Pre-configuration Tasks

Before configuring traffic policies for VXLAN packets, complete the following tasks:

  • Configure a VXLAN tunnel.
  • Bind a VNI to a BD/VPN.

Configuration Procedures

Figure 5-3 Flowchart for configuring MF classification for VXLAN packets
Updated: 2019-01-03

Document ID: EDOC1100055024

Views: 39156

Downloads: 155

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next