No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - QoS 01

This is NE40E V800R010C10SPC500 Configuration Guide - QoS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring PQ

Configuring PQ

This section describes how to configure priority queuing (PQ) on low-speed links for queues into which packets are classified.

Context

NOTE:

PQ applies only to AF2, AF3, AF4, EF, CS6, and CS7 queues.

The priority of queues to which PQ applies is higher than that of queues to which weighted fair queuing (WFQ) applies. If both PQ and WFQ are configured for the same queue, the one that is configured later takes effect.

Perform the following steps on the router.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run port-queue pq shaping pir { pir-value | percentage pir-percent }

    PQ parameters are set.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055024

Views: 22042

Downloads: 114

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next