No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - QoS 01

This is NE40E V800R010C10SPC500 Configuration Guide - QoS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring WFQ

Configuring WFQ

This section describes how to configure weighted fair queuing (WFQ) on low-speed links for queues into which packets are classified.

Context

Perform the following steps on the router.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

    NOTE:

    Queue scheduling on low-speed links can be configured only in the Multilink Point-to-Point (MP)-Group interface view, Global-MP-Group interface view, serial interface view, Trunk-Serial interface view.

  3. Perform one of the following steps based on the desired WFQ queue scheduling mode.

    • If the weight-based scheduling mode is needed, perform the following operations:
      1. Run the set port-queue weight-mode command to set the WFQ queue scheduling mode of the interface to Weight.
      2. Run the port-queue { cs7 | cs6 | ef | af4 | af3 | af2 | af1 | be } { wfq weight weight-value | shaping { shaping-value | shaping-percentage shaping-percentage-value } }* outbound command to configure WFQ scheduling parameters for an outbound port queue on the interface, including the weight and shaping rate.
    • If the CIR-based scheduling mode is needed, run the port-queue { cs6 | ef | af4 | af3 | af2 | af1 | be } wfq shaping cir { cir-value | percentage cir-percent } [ pir { pir-value | percentage pir-percent } ] command to configure WFQ queue scheduling parameters.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055024

Views: 23235

Downloads: 115

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next