No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - QoS 01

This is NE40E V800R010C10SPC500 Configuration Guide - QoS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring HQoS on a Low-speed Links Interface

Configuring HQoS on a Low-speed Links Interface

In HQoS, synchronous serial interfaces of the E1 channel are configured for a CPOS interface or an E1 interface. In this case, each user can access the network through a synchronous serial interface, better utilizing the interface bandwidth.

Usage Scenario

HQoS is mostly used on the user side of

  • A PE device of a backbone network

  • An access router of an access network.

In the case of multiple user access and multiple service access, HQoS can differentiate users in a network for priority scheduling and bandwidth guarantee. In addition, HQoS can also save the costs in network operation and maintenance.

Figure 8-3 Typical networking diagram for user access through interfaces

Pre-configuration Tasks

Before configuring HQoS, complete the following tasks:

  • Configuring IP addresses for the interfaces

  • Configuring IP routing protocol on the routers and ensure that the link works normally

  • Configuring simple traffic classification

NOTE:

Before you configure the HQoS function, it is recommended that you configure the simple traffic classification or complex traffic classification; otherwise, in FQ scheduling all traffic is considered BE by default.

Configuration Procedures

Figure 8-4 Flowchart of configuring HQoS on a low-speed links interface

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055024

Views: 25898

Downloads: 117

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next