No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - QoS 01

This is NE40E V800R010C10SPC500 Configuration Guide - QoS

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of PBR Based on Redirection to an MPLS-TE P2P Tunnel

Verifying the Configuration of PBR Based on Redirection to an MPLS-TE P2P Tunnel

After configuring policy-based routing (PBR), check the configurations.

Prerequisites

The configurations of PBR are complete.

Procedure

  1. Run the display ip policy-based-route command to check enabled PBR policies.
  2. Run the display policy-based-route [ policy-name ] command to check the created policy content.

Example

Run the display ip policy-based-route command. The command output shows enabled PBR policies.

<HUAWEI> display ip policy-based-route
policy Name                     Interface
aaa                          GigabitEthernet1/0/0
aaa                          GigabitEthernet2/0/0

Run the display ip policy-based-route command. The command output shows the created policy content.

<HUAWEI> display policy-based-route
-----------------------------------------------------
  User Defined policy-based-route Policy Information:
-----------------------------------------------------
    Total: 100  Used: 1  Free: 99
    Policy: aaa
        Node: 5     MapInstance: 5
              if-match acl a3001
              apply output-interface Tunnel30
        Node: 10    MapInstance: 10
              if-match acl a3002
              apply output-interface Tunnel40
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055024

Views: 30242

Downloads: 141

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next