No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - QoS 01

This is NE40E V800R010C10SPC500 Configuration Guide - QoS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Actions for PBR

Configuring Actions for PBR

Context

Each node in each policy for policy-based routing (PBR) needs to be configured with rules and an action. The action is redirecting matching IP packets to an outbound interface.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run policy-based-route policy-name permit node node-id map-instance map-instance-id

    A policy or node is created, and the policy-based-route view is displayed.

    NOTE:

    A maximum of 100 policies can be configured.

    A maximum of 200 nodes can be configured.

    The map-instance-id value must be the same as the node-id value.

  3. Run if-match acl name acl-number

    An ACL is configured to match against IP addresses.

  4. Run apply output-interface { interface-name | interface-type interface-number }

    The outbound interface to which packets are redirected is specified.

    NOTE:

    The outbound interface can only be a P2P TE Tunnel interface. If the tunnel type is changed , the configuration is deleted automatically for the PBR.

    The format of tunnel-name can be either of the following:
    • Tunnel interface-number. The format of interface-number is x/y/z.
    • Tunnel tunnel-number. The value of tunnel-number is an integer ranging from 0 to 4294967295.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055024

Views: 22492

Downloads: 115

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next