No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - QoS 01

This is NE40E V800R010C10SPC500 Configuration Guide - QoS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Applying a QPPB Local Policy to an Interface

Applying a QPPB Local Policy to an Interface

After a QPPB local policy is applied to an interface, the associated traffic behavior is performed for the packets that meet the matching rule.


You can apply a QPPB local policy to the incoming or outgoing traffic.

BGP routes in QPPB refer to only BGP routes on the public network. Private routes are involved in the QPPB application on the L3VPN.

Do as follows on a BGP route receiver:


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run one of the following commands as needed:

    • To apply a QPPB local policy to the incoming traffic, run the qppb-policy policy-name source inbound command on the inbound interface.

    • To apply a QPPB local policy to the outgoing traffic, run the qppb-policy qos-local-id source inbound and qppb-policy policy-name outbound commands on the inbound and outbound interfaces respectively.

    • To apply a QPPB local policy to the ip precedence, run the qppb-policy ip-precedence source command to apply QPPB policy for source or destination address based on the traffic behavior specified by route policy.

    The keyword source indicates that policies are applied to traffic along the route whose source address meets the matching rule.

Updated: 2019-01-03

Document ID: EDOC1100055024

Views: 25486

Downloads: 117

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next