No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - User Access 01

This is NE40E V800R010C10SPC500 Configuration Guide - User Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Disabling RADIUS Attributes

(Optional) Disabling RADIUS Attributes

You must enable RADIUS attribute translation before disabling RADIUS attributes.

Context

This function is configured for a RADIUS server group and takes effect on only the RADIUS servers in this group. You can disable up to 64 attributes in a RADIUS server group.

You can disable the RADIUS attributes of both the sender and receiver on the NE40E.

Perform the following steps on the router:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run radius-server group group-name

    The RADIUS server group view is displayed.

  3. Run radius-server attribute translate

    RADIUS attribute translation is enabled.

  4. Run either of the following commands to disable basic or extended RADIUS attributes:
    1. Run the radius-attribute disable attribute-name { receive | send } * command to disable basic RADIUS attributes for request or response packets.
    2. Run the radius-attribute disable attribute-name { access-accept | access-request | account [ start ] } * command to disable basic RADIUS attributes for Access-Accept, Access-Request, or accounting packets.
    3. Run the radius-attribute disable extend attribute-description { access-accept | { access-request | account } * } command to disable extended RADIUS attributes for Access-Accept, Access-Request, or accounting packets.
    4. Run the radius-attribute disable extend { attribute-description | vendor-specific src-vendor-id src-sub-attr-id }access-accept command to disable extended or user-defined RADIUS attributes for packets.
    5. Run the radius-attribute disable attribute-name { ip ip-address | string string | bin string | integer integer } receive command to disable RADIUS attributes with specified data types and carried in response packets.
    6. Run the radius-attribute disable { hw-acct-update-address | flow-attributes } integer integer account commamnd to disable RADIUS attributes with specified integral values and carried in accounting packets. Currently, the integer parameter can be set to 0 only.

      If you specify the flow-attributes parameter in the radius-attribute disable command, the following flow attributes are all disabled: Acct-Input-Octets, Acct-Output-Octets, Acct-Input-Packets, Acct-Output-Packets, Acct-Input-Gigawords, Acct-Output-Gigawords, HW-Acct-IPV6-Input-Octets, HW-Acct-IPV6-Output-Octets, HW-Acct-IPV6-Input-Packets, HW-Acct-IPV6-Output-Packets, HW-Acct-IPV6-Input-Gigawords, and HW-Acct-IPV6-Output-Gigawords.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055031

Views: 19375

Downloads: 87

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next