No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - User Access 01

This is NE40E V800R010C10SPC500 Configuration Guide - User Access
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring L2TP HQoS

(Optional) Configuring L2TP HQoS

To control the L2TP service traffic in a refined manner, you can configure L2TP HQoS.

Usage Scenario

In the application scenario of L2TP service wholesale, the LAC works on only the service wholesale, whereas the service control point is actually the LNS. An L2TP tunnel is set up between the LAC and the LNS. Therefore, you need to control the traffic that enters the L2TP tunnel and the service traffic in the tunnel on the LNS in a refined manner to minimize the effect of the unnecessary competition for service traffic between the LAC and the LNS on the service quality. In addition, carriers can control the traffic of different services that enter the backbone network to limit the burst traffic of users in the tunnel.

L2TP HQoS performs QoS scheduling on users at the LNS side, which aims at carrying out a comprehensive and detailed planning on the traffic that goes into the L2TP tunnel and the service traffic in the tunnel.

Pre-configuration Task

Before configuring L2TP HQoS, complete the following tasks:

  • Installing the tunnel board on the NE40E

  • Configuring L2TP for L2TP users to go online

Configuration Procedures

Figure 10-5 Flowchart for configuring L2TP HQoS
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055031

Views: 17275

Downloads: 70

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next