No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - User Access 01

This is NE40E V800R010C10SPC500 Configuration Guide - User Access
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring URPF for PPP Users

(Optional) Configuring URPF for PPP Users

Enabling URPF for PPP users prevents source address spoofing attacks.

Procedure

  • Configure URPF for PPPoE-type users.
    1. Run system-view

      The system view is displayed.

    2. Run interface virtual-template virtual-template-number

      A virtual template is created and the virtual template view is displayed.

    3. Enable URPF for PPPoE-type users.

      • For the IPv4 PPPoE-type users, run the ip urpf strict enable [ check subnet ] command to enable the IPv4 URPF function.

    4. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055031

Views: 17230

Downloads: 70

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next