No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - User Access 01

This is NE40E V800R010C10SPC500 Configuration Guide - User Access
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring PPPoE Access Services

Configuring PPPoE Access Services

Configuring PPPoE access services allows access control and accounting for hosts.

Usage Scenario

As network data services are developing rapidly, broadband users are increasing explosively. Carriers need an access device that can provide access services for multiple remote hosts and also provide user access control and accounting. Ethernet is the most economical technology for connecting multiple hosts to access devices, and PPP provides well-developed user access control and accounting. However, PPP cannot be applied to Ethernet. To address this problem, PPPoE has been developed. PPPoE is a link layer protocol that transmits PPP datagrams through PPP sessions established over point-to-point connections on Ethernet networks. As a supplement to PPP, PPPoE allows a remote access device to provide access services for hosts on Ethernet networks and to implement user access control and accounting. With these features, PPPoE is widely acknowledged among broadband access carriers, and therefore widely applied.

Pre-configuration Tasks

Before configuring PPPoE access services, complete the following tasks:

  • Configure AAA schemes.

  • Configure a server template.

  • Configure a local or remote IPv4 address pool.

  • Configure a domain.

Configuration Procedures

Perform the following configurations as required.

Figure 7-3 Flowchart for configuring PPPoE access
Updated: 2019-01-03

Document ID: EDOC1100055031

Views: 17344

Downloads: 70

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next