No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - User Access 01

This is NE40E V800R010C10SPC500 Configuration Guide - User Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an L2TP Tunnel

Configuring an L2TP Tunnel

An L2TP tunnel can be used to provide access services for enterprises, small ISPs, and the staff on business trips over a public network.

Context

For details, see L2TP Protocol Configuration in the HUAWEI NetEngine40E Universal Service Router Configuration Guide - User Access.

NOTE:

The preference of the route from the LNS to the master LAC is higher than that of the route from the LNS to the backup LAC. The LNS will switch traffic to the route destined for the backup LAC only when a fault occurs on the network side of the master LAC.

In L2TP dual-device hot backup scenarios, if an L2TP tunnel is established on an L3VPN, URPF is configured on the LACs' network side, and the master LAC's access side fails, downstream traffic packets are discarded on the backup LAC.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055031

Views: 19357

Downloads: 85

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next