No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - User Access 01

This is NE40E V800R010C10SPC500 Configuration Guide - User Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling the L2TP Function

Enabling the L2TP Function

After L2TP is enabled and an L2TP group is configured on an LAC and an LNS, an L2TP tunnel can be set up between the LAC and the LNS.


L2TP functions can be used only after L2TP is enabled. When L2TP is disabled, even if L2TP parameters are configured, the NE40E does not provide L2TP functions.

Perform the following steps on the NE40E:


  1. Run system-view

    The system view is displayed.

  2. Run l2tp enable

    L2TP is enabled.

  3. Run commit

    The configuration is committed.

Updated: 2019-01-03

Document ID: EDOC1100055031

Views: 17381

Downloads: 70

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next