No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - User Access 01

This is NE40E V800R010C10SPC500 Configuration Guide - User Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Idle-Cut Timer of a Tunnel

Configuring the Idle-Cut Timer of a Tunnel

To save bandwidth resources, you can set the idle-cut timer.

Context

The idle-cut timer specifies the period during which a tunnel exists after the number of sessions in the tunnel reaches 0. When the timer expires, the tunnel is deleted.

Perform the following steps on the NE40E:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run l2tp-group group-name

    The L2TP group view is displayed.

  3. Run tunnel idle-cut time

    The idle-cut timer is configured.

    If the idle-cut timer of the tunnel is set to 0, it indicates that the tunnel will not be deleted automatically. However, if the remote end deletes the tunnel, it cannot be set up again.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055031

Views: 17405

Downloads: 70

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next