No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - User Access 01

This is NE40E V800R010C10SPC500 Configuration Guide - User Access
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting NAS Parameters

Setting NAS Parameters

By setting NAS parameters, you can ensure that the master and backup servers send the same information to the remote server.

Context

To allow users to log in through the backup device twice authentication, perform the following operations on the devices that back up each other:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run remote-backup-profile profile-name

    The RBP view is displayed.

  3. Run service-type bras

    The RBS of the BRAS user information is enabled.

  4. Run nas { logic-ip ip-address | logic-port [ interface-name | interface-type interface-number ] | logic-sysname host-name }

    The logic IP address, logic interface, and logic host name are configured. Ensure that the devices that back up each other send the same information about NAS-IP-Address, NAS-Port, NAS-Port-ID, and Option 82 contained in the packets to the RADIUS and DHCP servers.

    By default, you are advised to set NAS-IP-Address on the master device to be the same as that on the backup device. If you run the radius-authorization source same-as nas-logic-ip command to set NAS-IP-Address to the source IP address of packets sent to the RADIUS server, the master and backup devices must have different NAS-IP-Address values. If the RASIUS server checks binding authentication, the master and backup devices must have the same NAS-IP-Address value. In this case, NAS-IP-Address cannot be set to the source IP address of packets sent to the RADIUS server.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055031

Views: 17161

Downloads: 69

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next