No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - User Access 01

This is NE40E V800R010C10SPC500 Configuration Guide - User Access
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring DHCPv4 Operation Status

Monitoring DHCPv4 Operation Status

You can monitor the DHCPv4 operating status by checking the configurations of an IPv4 address pool, a DHCPv4 server, and the path at which DHCPv4 data is saved and file information about the data.

Prerequisites

In routine maintenance, you can run the following command in any view to check the DHCPv4 operating status.

Procedure

  • Run the display ip pool [ name pool-name [ section-num [ start-ip-address [ end-ip-address ] ] | all | used ] ] [ vpn-instance vpn-instance-name ] command to check the configuration of the IP address pool.
  • Run the display dhcp-server group [ group-name ] command to check the configuration of the DHCPv4 server group.
  • Run the display dhcp-server item ip-address [ vpn-instance vpn-instance ] command to check information about a DHCPv4 server.
  • Run the display dhcp-server statistics ip-address [ vpn-instance vpn-instance ] [ verbose ] command to check the statistics on a DHCPv4 server.
  • Run the display dhcp relay address { all | interface interface-type interface-number | vlan vlan-id } command to check configurations about interfaces where DHCPv4 relay is enabled.
  • Run the display dhcp-access statistics packet command to check statistics about DHCPv4 services.
  • Run the display ip-pool max-usage { pool [ pool-name ] | domain [ domain-name ] } command in any view to check the historical maximum usage of addresses in an IPv4 address pool.
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055031

Views: 17143

Downloads: 69

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next