No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Configuration Guide - User Access 01

This is NE40E V800R010C10SPC500 Configuration Guide - User Access
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling an L2TP RBS

Enabling an L2TP RBS

An RBS can be enabled to back up L2TP services.


Perform the following steps on each of routers that back up each other:


  1. Run system-view

    The system view is displayed.

  2. Run remote-backup-profile profile-name

    The RBP view is displayed.

  3. Run service-type l2tp

    An L2TP RBS is enabled.


    If information about an L2TP tunnel, an L2TP session, or a PPPoE session has been backed up, the undo service-type l2tp command cannot be run.

Updated: 2019-01-03

Document ID: EDOC1100055031

Views: 17233

Downloads: 70

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next