No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Configuration Guide - User Access 01

This is NE40E V800R010C10SPC500 Configuration Guide - User Access
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring LAC-side User Access

Configuring LAC-side User Access

This section describes how to configure LAC-side user access to implement control and accounting for each access host.

Context

In L2TP access scenarios, users access the network through the LAC. Therefore, you need to configure an access mode and access interface on the LAC.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface virtual-template virtual-template-number

    A VT is created and its view is displayed, or the view of an existing VT is displayed.

  3. Run ppp authentication-mode { auto | { pap | chap | mschapv1 | mschapv2 } * }

    A PPP authentication mode is configured.

  4. Run quit

    Return to the system view.

  5. Run interface interface-type interface-number [ . subinterface-number ]

    The interface or sub-interface view is displayed.

    This interface is the physical interface through which users go online. The main interface view is displayed for PPPoE access users and the sub-interface view is displayed for PPPoEoVLAN access users.

  6. Run pppoe-server bind virtual-template vt-number

    The VT is bound to the interface.

  7. Run user-vlan { start-vlan [ end-vlan ] [ qinq start-qinq-id [ end-qinq-id ] ] | any-other }

    User-side VLANs are created.

  8. Run bas

    A BAS interface is created, and the BAS interface view is displayed.

  9. Run access-type layer2-subscriber [ default-domain { authentication [ force | replace ] dname | pre-authentication predname } * | bas-interface-name bname | accounting-copy radius-server rd-name ] *

    The access type and relevant attributes are configured for Layer 2 access users.

    When setting the access type on a BAS interface, you can set the service attributes of the access users at the same time or later.

    The access type cannot be configured on the Ethernet interface that is added to an Eth-Trunk interface. You can configure the access type only on the Eth-Trunk interface.

  10. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055031

Views: 17362

Downloads: 70

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next