No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Feature Description - IP Services 01

This is NE40E V800R010C10SPC500 Feature Description - IP Services
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Intra-VLAN Proxy ARP Application

Intra-VLAN Proxy ARP Application

Networking Description

As shown in Figure 2-17, to facilitate ease of management, communication isolation is implemented for various departments on the intranet of a company. For example, although Host A of the president's office, Host B of the R&D department, and Host C of the financial department belong to the same VLAN, they cannot communicate at Layer 2. However, the business requires that the president's office communicate with the financial department. To permit this, enable intra-VLAN proxy ARP on the CE so that Host A can communicate with Host C.

  • Before intra-VLAN proxy ARP is enabled, if Host A sends an ARP request message for the MAC address of Host C, the message cannot be broadcast to hosts of the R&D department and financial department because port isolation is configured on the CE. Therefore, Host A can never learn the MAC address of Host C and cannot communicate with Host C.

  • After intra-VLAN proxy ARP is enabled, the CE does not discard the ARP request message sent from Host A even if the destination IP address in the message is not its own IP address. Instead, the CE sends the MAC address of its VLANIF4 to Host A. Host A then sends IP datagrams to this MAC address.

Figure 2-17 Intra-VLAN proxy ARP networking

NOTE:

The type of interface 1 could be dot1q termination sub-interface or VLANIF interface.

Feature Deployment

Configure interface 1, which is a Layer 3 interface, on the CE, and enable intra-VLAN proxy ARP. After the deployment, the CE sends the MAC address of its interface 1 to Host A when receiving a request for the MAC address of Host C from Host A. Host A then sends IP datagrams to the CE, which forwards the IP datagrams to Host C. Consequently, the communication between Host A and Host C is implemented.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055041

Views: 11313

Downloads: 50

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next