No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Feature Description - IP Services 01

This is NE40E V800R010C10SPC500 Feature Description - IP Services
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Global UCMP

Global UCMP

Interfaces Supporting Global UCMP

The following types of interfaces support global UCMP:

  • Ethernet interfaces

  • GE interfaces

  • POS interfaces

  • Eth-Trunk interfaces

  • IP-Trunk interfaces

  • Serial interfaces

  • MP-Group interfaces

Enabling Global UCMP

Global UCMP requires that multiple outbound interfaces that support global UCMP exist. If one of these interfaces does not support UCMP, traffic is evenly distributed on other interfaces, regardless of the bandwidths of these interfaces after global UCMP is enabled.

After global UCMP is enabled on all interfaces that support UCMP, all routes are delivered to the interface board and bandwidth information about load balancing on each outbound interface is delivered in the same way as interface-based UCMP. Then, the interface board calculates the distribution ratio according to the bandwidth of each outbound interface.

When a large number of routes exist, a global command is set to avoid the pressure from delivering all routes to the system. The interval between enabling and disabling global UCMP is 5 minutes.

Interface Bandwidth Change Processing

  • When the interface bandwidth changes because a member interface is added to or removed from a logical interface or a member interface goes Up or Down, the modules related to logical interfaces, such as the trunk, inform the interface management module of the new bandwidth of each interface. Then, the interface management module sends an event message informing the FIB module of bandwidth changes. After verification, the FIB module informs all interface boards of bandwidth changes on interfaces. Consequently, the interface boards calculate the traffic ratio. If routing calculations are caused by interface bandwidth changes, the FIB module resends FIB entries.

  • Processing interface bandwidth changes takes time so that the CPU may be busy processing frequent changes of interface bandwidths. To avoid this problem, you can set an interval for reporting changes of interface bandwidth to interface boards. If the interface bandwidth changes multiple times within the interval, the latest bandwidth is reported to interface boards.

Precautions

If global UCMP is enabled, interface-based UCMP cannot be enabled. Similarly, if interface-based UCMP is enabled, global UCMP cannot be enabled.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055041

Views: 11277

Downloads: 50

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next