No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Feature Description - Network Reliability 01

This is NE40E V800R010C10SPC500 Feature Description - Network Reliability
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application of Bit-Error-Triggered Protection Switching in a Scenario in Which a Static CR-LSP/PW Carries L2VPN Services

Application of Bit-Error-Triggered Protection Switching in a Scenario in Which a Static CR-LSP/PW Carries L2VPN Services

Networking Description

Figure 9-20 shows a typical IP RAN. L2VPN services are carried on static CR-LSPs. CR-LSP APS is configured to provide tunnel-level protection. Additionally, PW APS/E-PW APS is configured for L2VPN services to provide service-level protection.

Figure 9-20 IP RAN using static CR-LSPs to carry L2VPN services

Feature Deployment

To meet high reliability requirements of the IP RAN and protect services against bit errors, configure bit-error-triggered protection switching for the CR-LSPs/PWs. To do so, enable bit error detection on the interfaces along the CR-LSPs/PWs, configure the switching type as trigger-LSP, and configure bit error alarm generation and clearing thresholds. If the BER reaches the bit error alarm threshold configured on an interface of a device along a static CR-LSP or PW, the device determines that a bit error occurrence event has occurred and notifies the MPLS-TP OAM module of the event. The MPLS-TP OAM module uses AIS packets to advertise the bit error status to the egress, and then APS is used to trigger a traffic switchover.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055045

Views: 13229

Downloads: 36

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next