No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Feature Description - System Monitor 01

This is NE40E V800R010C10SPC500 Feature Description - System Monitor
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview of Ping and Tracert

Overview of Ping and Tracert

Definition

The ping command is a very common debugging tool used to test the accessibility of devices. It uses a series of Internet Control Message Protocol (ICMP) Echo messages to check the following:

  • Whether the remote device is available

  • Round-trip delay in communicating with the remote host

  • Packet loss

The tracert command is used to test the path that packets pass between a source host and a destination host.

Purpose

If a device is faulty, use the ping and tracert commands to check network connectivity.

The ping command is used to test network connectivity and host accessibility. This command instructs the source host to send an ICMP Request message to a destination host and waits for an ICMP Reply message.

The tracert command is used to check the network connectivity and locate faulty nodes.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055050

Views: 5712

Downloads: 29

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next