No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Installation Guide

This is NE40E V800R010C10SPC500 Installation Guide
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Type and Structure

Type and Structure

Signal Cable Label

A signal cable label is L-shaped with fixed dimensions, as shown in Figure 6-1.
Figure 6-1 Signal cable label

To clearly specify the position of a cable, dividing lines are used on the label. For example, there is a dividing line between the cabinet number and chassis number, and another one between the chassis number and slot number. A dividing line is 1.5 mm (0.06 in.) x 0.6 mm (0.02 in.) in size with the color of PONTONE 656c (light blue).

The label can be folded along the perforated line and its size is 1 mm (0.04 in.) x 2 mm (0.08 in.).

Write information about the other end of the cable after "TO:" (which is upside down in Figure 6-1) in the lower right corner of the label.

Power Cable Label

A power cable label must be attached to an identification plate with a cable tie. Attach a label to the recess area in the middle of the identification plate, as shown in Figure 6-2.

Figure 6-2 Power cable label

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055059

Views: 40816

Downloads: 292

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next