No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Installation Guide

This is NE40E V800R010C10SPC500 Installation Guide
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Optical Connectors

Optical Connectors

The NE40E uses the following types of optical connectors:

  • LC/UPC optical connector

  • SC/UPC optical connector

  • FC/UPC optical connector

  • MPO/PC optical connector

The outlines and operations of the connectors and the precautions that you should take when plugging and unplugging the connectors are described in the following sections.

LC/UPC Optical Connector

Figure 3-38 shows the outline of the LC/UPC optical connector.

Figure 3-38 LC/UPC optical connector



The plugging/unplugging of LC/UPC optical interface only needs an axial operation instead of a rotation.

The operation procedures and precautions are as follows:

  • Cautiously align the head of the fiber jumper with the optical interface on the optical board and push in the fiber with proper strength.

  • Press the clip before pulling it out. Push in the fiber connector inward slightly, and then pull out the connector.

SC/UPC Optical Connector

Figure 3-39 shows the outline of the SC/UPC optical connector.

Figure 3-39 SC/UPC optical connector



FC/UPC Optical Connector

Figure 3-40 shows the outline of the FC/UPC optical connector.

Figure 3-40 FC/UPC optical connector



MPO/PC Optical Connector

Figure 3-41 shows the outline of the MPO/PC optical connector.

Figure 3-41 MPO/PC optical connector



The plugging/unplugging of MPO/PC optical interface only needs an axial operation instead of a rotation.

The operation procedures and precautions are as follows:

  • Cautiously align the head of the fiber jumper with the optical interface on the optical board and push in the fiber with proper strength.
  • When pulling it out, unlatch the lock sleeve, and then pull out the connector.
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055059

Views: 40813

Downloads: 292

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next