No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Installation Guide

This is NE40E V800R010C10SPC500 Installation Guide
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Unpacking the Box Containing the Carton and Wooden Tray

Unpacking the Box Containing the Carton and Wooden Tray

Space permitting, carry the carton into or near the equipment room before you unpack it. This can prevent the chassis from being damaged when moved without protective packaging.

Prerequisites

  • The carton cannot stand strength. To move a carton, use the pallet trunk to move the wooden tray under the carton.
  • The wooden case must be positioned correctly. Do not place the wooden case upside down. Otherwise, the device can get damaged severely.
  • Check the tiltwatch label. If the tiltwatch turns red, the carton was tilted during delivery. If the device in the carton is damaged in this case, the delivery party should be responsible for the damage.

Procedure

  1. Wear protective gloves.
  2. Place the wooden case in an even manner on the ground, and make sure that the side with the pallet faces downwards.
  3. Cut all wrapping tapes using knives or scissors.
  4. Remove the top of the carton, as illustrated by (1) in Figure 2-6.
  5. Open the carton, as illustrated by (2) in Figure 2-6.
  6. Remove the two foamed plastic materials from the chassis top, as illustrated by (3) and (4) in Figure 2-6.
  7. Separate the chassis from wooden tray using a socket wrench, as illustrated by (5) in Figure 2-6.
  8. Remove the fixed component at the bottom of the chassis using a Phillips screwdriver.

    Figure 2-6 Unpacking

  9. Check the cabinet according to the following requirements:

    Four to five persons are required to stand the cabinet. When standing the cabinet, prevent the cabinet from tipping over, as this may cause injury to the personnel who are handling it.
    • Check the appearance of the chassis. Ensure that the exterior (especially the bottom) of the chassis is intact, free from water penetration, distortion, and rust.
    • Check the surface of the chassis. Ensure that the surface of the chassis is clean, neat and completely painted.
    • Check the labels on the chassis. Ensure that the labels on the chassis are correct, legible and complete.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055059

Views: 39355

Downloads: 283

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next