No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Installation Guide

This is NE40E V800R010C10SPC500 Installation Guide
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Requirements for Handling Corrosive Gases

Requirements for Handling Corrosive Gases

The room must be free from corrosive gases, such as SO2, H2S, and NH3. Table 2-15 lists the requirements for corrosive gas concentrations. For details, see the indoor requirements specified in the GR-63 standard.
Table 2-15 Requirements for corrosive gas concentrations

Chemically Active Substance





≤ 50



≤ 40



≤ 500



≤ 5

Take the following measures to ensure that the preceding requirements can be met:
  • Avoid constructing the equipment room near a place where there is a high concentration of corrosive gases, such as a chemical plant.
  • Ensure the air intake vent of the room is always upwind of the pollution source, and is far away from any sewers.
  • Use environmental protection decoration materials. For example, use the Polyethylene Foam (PEF) to replace the rubber and plastic foam.
  • Do not place batteries together.
  • Monitor the corrosive gas concentrations regularly.
Updated: 2019-01-03

Document ID: EDOC1100055059

Views: 40841

Downloads: 292

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next