No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C10SPC500 Installation Guide

This is NE40E V800R010C10SPC500 Installation Guide
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing Optical Fibers

Installing Optical Fibers

Installing Fiber Spools and Optical Modules

  • Wear an ESD wrist strap or ESD gloves before installing optical modules.
  • Cover idle optical modules with dust caps, as shown in 3 in Figure 10-38.
  • If cabinets need to be combined, install fiber spools on a side of each cabinet before you combine the cabinets.
  • The number of fiber spools to be installed depends on the actual requirements. To facilitate fiber management and routing, do not install two fiber spools on the same side of a cabinet.
  1. Install fiber spools, as shown in 1 in Figure 10-38.
  2. Install optical modules, as shown in 2 in Figure 10-38.
    Figure 10-38 Installing fiber spools and optical modules

Installing Optical Fibers

  • The clearance between the power cable, ground cable, and signal cable must be greater than 30 mm (1.18 in.) each. The bending radius of an optical fiber must be greater than 40 mm (1.57 in.).
  • Dust caps must be installed on optical modules that are not connected to any optical fibers.
  • Do not bundle optical fibers too tightly. You must be able to conveniently remove a single fiber from the bundle.

To install optical fibers, perform the following steps:

  1. Attach temporary labels to both ends of each optical fiber.
  2. Bind the optical fibers, and then insert each bundle of optical fibers into a corrugated pipe.
  3. To mark and reinforce the edges of the pipe, wrap electrical tape around both ends, as shown in 1 in Figure 10-39.
  4. Route the corrugated pipe along the cable ladder.
  5. Lead the corrugated pipe about 100 mm (3.93 in.) in to the cabinet through the top opening. Secure the pipe to the cabinet using cable ties. See 2 in Figure 10-39.
    Figure 10-39 Inserting the corrugated pipe

  6. Route optical fibers along the cable tray. Remove dust caps from the optical modules and protective caps from optical fibers. Then connect the optical fibers to the corresponding optical modules, as shown in 1 in Figure 10-40.
  7. Connect the other end of each optical fiber to the Optical Distribution Frame (ODF).
  8. Coil the excess length of optical fiber around the fiber spool, as shown in 2 in Figure 10-40.
  9. Use cable ties to bundle optical fibers every 150 mm (5.91 in.) and secure them to the cable tray.
  10. Attach permanent labels 20 mm (0.79 in.) from both ends of each optical fiber, as shown in 3 in Figure 10-40.
    Figure 10-40 Installing optical fibers

Updated: 2019-01-03

Document ID: EDOC1100055059

Views: 43656

Downloads: 319

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next