No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Installation Guide

This is NE40E V800R010C10SPC500 Installation Guide
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing Boards and Subcards

Installing Boards and Subcards

Slot Layout

The following figure shows the slot layout of the NE40E-X3A.

Figure 12-18 Slot layout

Interface Numbering

An interface is numbered in the format of slot number/card number/port number.

  • Slot number: On the NE40E-X3A, the slots of LPUs are numbered from 1 to 3.
  • Card number: The cards of LPUs are numbered beginning with 0. If there is no card on a board, the card number is set to 0.
  • Port number: The ports of LPUs are numbered beginning with 0.

Installing Boards and Subcards

  • Ensure that no water is on the device or board before you insert the board into the device.
  • Before you install boards, wear the ESD wrist strap or ESD gloves to prevent electrostatic discharge from the human body from damaging the sensitive components.
  • Insert filler panels to empty slots.

Installing a board

To install a board, perform the following steps:

  1. Remove the filler panel from the slot.
  2. Insert the board smoothly along the guide rails in the slot.
  3. Use a Phillips screwdriver to tighten the captive screws.
    Figure 12-19 Installing a board

Installing a subcard

To install a subcard, perform the following steps:

  1. Insert a subcard along the guide rails in the slot on the board.
  2. Use a Phillips screwdriver to tighten the captive screws.
    Figure 12-20 Installing a subcard

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055059

Views: 39265

Downloads: 283

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next