No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Installation Guide

This is NE40E V800R010C10SPC500 Installation Guide
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing the Mould of a Crimping Tool

Replacing the Mould of a Crimping Tool

This section describes how to replace the mould of a crimping tool.

Procedure

  1. Hold the handles of the crimping tool. Loosen the two fastening screws, as shown in Figure 4-79.

    Figure 4-79 Loosening two fastening screws

  2. Hold the handles of the crimping tool to open the self-locking lock. At this time, the jaw of the crimping tool opens automatically, as shown in Figure 4-80.

    Figure 4-80 Pliers jaw opening automatically

  3. Remove the mould from the crimping tool, as shown in Figure 4-81.

    Figure 4-81 Removing the mould from the crimping tool

  4. Place the new mould into the jaw of the crimping tool and align the screw holes, as shown in Figure 4-82.

    Figure 4-82 Installing a new mould in the crimping tool

    Keep the short side of the mould inwards and the long side outwards. The teeth of the mould should go from largest toward the inside to smallest toward the outside.

  5. Hold the handles of the crimping tool tightly to match the mould and the jaw completely. Align the screw holes, as shown in Figure 4-83.

    Figure 4-83 Aligning the screw holes

  6. Hold the handles of the crimping tool with one hand. Tighten the two fastening screws. Figure 4-84 shows the mould installed in the crimping tool.

    Figure 4-84 Mould installed in the crimping tool

    Figure 4-85 shows the finished crimping tool.

    Figure 4-85 Finished crimping tool

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055059

Views: 43352

Downloads: 319

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next