No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C10SPC500 Installation Guide

This is NE40E V800R010C10SPC500 Installation Guide
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Unpacking the Wooden Case

Unpacking the Wooden Case

In general, wooden cases are used to pack heavy goods such as racks, cabinets and batteries. The package for a cabinet consists of wooden panels, steel edges, tongues, and foam plates. If possible, move the wooden case into or near the equipment room, and then unpack the cabinet to avoid damaging the cabinet during transportation.

Prerequisites

  • When carrying the cabinet, always hold the stronger part of the cabinet, such as the support or the rack. Do not exert force on the parts that are relatively weak, such as the cable support or the cable fixing beam. Otherwise, the cabinet may get damaged or accidents may occur. Remove the backing blocks from the rack only after the cabinet is carried to the installation site. The same is to avoid damaging signal cables and boards when carrying the cabinet.
  • If there are violent-strike sensing labels, check whether the label is red. If the label is not red, you need not check the equipment. If the label is red, check whether the equipment is damaged and maintain records.
  • The wooden case must be positioned correctly. Do not place the wooden case upside down. Otherwise, the device can get damaged severely.

Procedure

  1. Wear protective gloves.
  2. Place the wooden case in an even manner on the ground, and make sure that the side with the pallet faces downwards.
  3. Insert one end of the spanner into the hole of the tongue on the cover of the wooden case. Lift the spanner to straighten the tongue, as shown in Figure 2-3. You can also use a screwdriver or a claw hammer to straighten the tongue.

    Figure 2-3 Straightening the tongue

    1 Steel edge

    2 Wooden panel

    3 Tongue

    4 Spanner

    The edges of tongues are sharp and may injure your hand.

  4. After straightening all the tongues on the cover, remove the cover as shown in Figure 2-4.

    Figure 2-4 Removing the cover



  5. Straighten all the tongues that join the side wooden panels and remove the wooden panels, as shown in Figure 2-5.

    Figure 2-5 Removing the side wooden panels



  6. Stand the cabinet. Remove the pallet, foam plates, and package bag.

    Three to five persons are required to stand the cabinet. When standing the cabinet, prevent the cabinet from tipping over, as this may cause injury to the personnel who are handling it.

  7. Check the cabinet according to the following requirements:

    • Check the appearance of the cabinet. Ensure that the exterior (especially the bottom) of the cabinet is intact, free from water penetration, distortion, and rust.
    • Check the cabinet door. Ensure that the cabinet door can be opened and closed normally.
    • Check the surface of the cabinet. Ensure that the surface of the cabinet is clean, neat and completely painted.
    • Check the labels on the cabinet. Ensure that the labels on the cabinet are correct, legible and complete.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055059

Views: 39456

Downloads: 286

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next