No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Inter-AS Seamless MPLS

Configuring Inter-AS Seamless MPLS

In the inter-AS seamless MPLS networking, the access and aggregation layers belong to one AS, and the core layer belong to another AS. An inter-AS BGP LSP is established across the three layers to implement E2E service connectivity.

Usage Scenario

In Figure 5-3, the access and aggregation layers belong to one AS, and the core layer belongs to another AS. Inter-AS seamless MPLS can be configured to transmit services between NodeBs that are Ethernet stations and an Mobility Management Entity (MME) or Serving Gateway (SGW).

Figure 5-3 Inter-AS seamless MPLS networking

NOTE:
When inter-AS seamless MPLS is configured for an L3VPN, BGP LSPs can be iterated to load-balancing LDP, TE, or LDP over TE tunnels and support ECMP.

Pre-configuration Tasks

Before configuring inter-AS seamless MPLS, complete the following tasks:

  • Configure IGP protocols to implement connectivity at the access, aggregation, and core layers and enable MPLS LDP or MPLS TE to implement MPLS forwarding on a public network.

  • Configure an EBGP peer relationship between each pair of an AGG ASBR and core ASBR and an IBGP peer relationship between each pair of the following nodes:
    • Cell Site Gateway (CSG) and Aggregation (AGG)
    • AGG and AGG ASBR
    • Core ASBR and Mobile Aggregate Service Gateway (MASG)
NOTE:

If MPLS TE tunnels are used across the three layers, a tunnel policy or tunnel selector must be configured. For configuration details, see VPN Tunnel Management Configuration.

Configuration Procedures

Figure 5-4 Flowchart for configuring inter-AS Seamless MPLS
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19843

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next